+86 0371 8654 9132

marble powder instead of sand in cement concrete

Use of Waste Marble Powder as Partial Replacement in ...

marble dust powder on the concrete mix by partially replacing cement and sand with the marble powder dust. In this project, we check the effect on mechanical and physical properties of a concrete mix if varying marble powder dust is partially replaced in the concrete mix. 1.1 Research Significance

Use of Waste Marble Powder as Partial Replacement in ...

May 18, 2015 · But the split tensile strength decreased for the mix which contains 20 % marble powder dust against cement (10%) and sand (10%) by 11%. Hence result shows that marble powder when mixed with sand and cement together has low split strength as compared to the replacement of marble waste in cement and sand individually. 3.3 Durability.

Feasibility of waste marble powder in concrete as partial ...

Jan 01, 2018 · The process of cement manufacturing contributes to greenhouse gas emission which is responsible for producing global warming. The use of industrial by-products like coal ash, waste plastics, rubber tire scrap, waste glass, foundry sand, marble powder and so forth in place of cement, sand can lead to sustainable development.

Study of Properties of Concrete using Marble Powder and ...

Marble powder and dredged sand in concrete production, which would reduce both the environmental impact and the production cost. Keywords-Fine aggregate, marble powder, dredged sand, I. INTRODUCTION . Concrete is the important material in the construction other than steel and timber. Its main constituents are cement, sand,

Partial Replacement of Cement With Marble Powder in Concrete

The test results show that the compressive strength, split-tensile strength and flexural strengths are achieved up to 30% to 40% replacement of cement with marble powder without affecting the characteristic strength of M20(1:1.5:3) grade concrete. KEYWORDS: Cement (53 grade), Marble powder, Fine aggregate (M-sand), Coarse aggregate (20mm size).

Waste marble powder/dust - ScienceDirect

Jan 01, 2018 · Fresh concrete behavior in conventional concrete produced with waste marble powder by replacing (A) sand and (B) cement. The fresh concrete properties of the SCC almost make up the main production purpose of this type of concretes.

Cement Replacement in concrete with Marble Dust Powder

of concrete is increased by replacement of cement with marble dust powder up to 10%, and after than adding extra percentage of marble dust powder by replacement of cement, the compressive strength of concrete is start to decrease. According to this study, the replacement of cement up to 10% with marble dust powder in M-20 grade

The effect of the using waste marble dust as fine sand on ...

Cost of concrete is reduced by using the marble dust, also the economic [36] and ecocofficient polymer is obtained by using dust instead of cement or sand. It was concluded that the production of ...

Reusing of marble and granite powders in self-compacting ...

May 10, 2016 · Corinaldesi et al. (2010) reported that using of 10% marble powder (MP) as sand replacement in mortar is better than being used as cement replacement material. Moreover, the use of superplasticizer is necessary to compensate the high water demand of

Can we make concrete using quarry dust as a replacement ...

Answer (1 of 7): Of course. Quite a standard procedure. We call it crusher dust, or manufactured sand. Dependent on the source rock and type of crusher, the particle shape is unlikely to be nice round grains, which makes for concrete that is not quite as nice to play with, but it is still far fr...

Properties of concrete incorporating waste marble powder ...

Ashish et al. (2016) evaluated whether marble powder is best suitable for replacement of cement or sand, and reported that marble waste is better suited for replacement of sand only. ...

PARTIAL REPLACEMENT OF FINE AGGREGATE BY MARBLE

(instead of sand). The concrete is prepared with marble powder as a partial replacement of fine aggregate in various proportions and laboratory tests like compressive strength test and workability test etc will be carried out.

Experimental Study On Concrete Using Waste Marble powder ...

powder waste is increased by 15% and by further increasing of waste marble powder, compressive strength gets reduced. Specimens were casted in (150x150x150) mm moulds. keywords: Marble powder, Sand, concrete ,compressive strength, split tensile strength. 1 INTRODUCTION Cement, sand and aggregate are basic needs for any construction industry.

(PDF) Use of waste marble aggregates in concrete | Elhem ...

upon cement or sand substitution by the marble powder. ... 10% and 15% marble and limestone dusts instead of fine sand Experiments carried out by Saboya et al. [4] have shown that the aggregates and their compressive strengths were compared. ... 21.86 17.56 5.7 powder for its use in mortar and concrete. Construct Build Mater 25.08 2010;24:113–7.

Re-use of waste marble dust in the production of cement ...

Kumar 2015, Vaidevi 2013;Rodrigues et al 2015;Ergün 2011) studied the effect of different percentage of substitution of cement by marble powder on compressive strength, the results of this ...

Project on Partial Replacement of Cement with Marble Powder

QUANTITY OF MARBLE POWDER; 5% of cement replaced by marble powder = 377.38gm 10% of marble powder = 754.7 gm 15% of marble powder = 1.13 kg 20 %of marble powder = 1.5094 kg. Experimental conditions: Compressive strength of concrete was undertaken on 15 cm cubic specimens. at 7 days and 28 days of age.

Can marble powder be mixed with concrete? - Quora

Answer: The advancement of concrete technology can reduce the consumption of natural resources and energy sources and lessen the burden of pollutants on environment. Presently large amounts of marble dust are generated in natural stone processing plants with an important impact on environment and...

An Experimental investigation on utilizations of Marble ...

3.2 COMPRESSIVE STRENGTH - Compressive strength of concrete mixes with various percentage of marble dust as replacement of cement at age of 7 days and 28 days respectively are shown in Fig.3 and Fig.4. From Table 10 and 11 it can be observed that with the replacement of cement with marble dust for 5% & 10% there is an increase in the strength at 7days as well as at 28 days.

Marble Powder Lab - 2221 Words | Internet Public Library

To observe the performance of concrete prepared by replacement of cement and sand by marble powder as well as addition of marble powder to the standard concrete these tests were performed. For compressive strength cubes of dimensions 150mm×150mm×150mm were prepared. To check the repeatability of results three cubes of each mix were prepared ...

Synergistic Effect of Marble Powder and Green Sand on the ...

Feb 04, 2019 · This study mainly aims at utilizing marble powder and green sand as partial substitute for fine aggregate and metakaolin for cement. From the experimental results obtained the following conclusions can be withdrawn. The workability of the concrete was very much influenced due to the addition of green sand and marble powder.

Experimental and Theoretical Study of a New Technique for ...

The marble powder was also used as an additive material in blended cement . This cement has been obtained by intergrinding marble powder with Portland cement clinker at different blend ratios. Obtained results indicate that adding 10% of marble powder provides cement that conforms to EN 197-1 standard . In addition, the marble powder was also ...

Civil Engineer must know These Tips & Tricks - CIVIL SITE ...

Sep 12, 2019 · Ans: Terrazzo is a special type of cement concrete. This concrete consists of white cement instead of grey cement and marble powder instead of sand and marble chips as coarse aggregate instead of stone aggregates. 7.CUBE SAMPLES: 1 – 5 m3 = 1 Nos (Means 3 for 7 Days and 3 for 28 Days) 6 – 15 m3 =2 Nos. 16 – 30 m3 =3 Nos. 31 -50 m3 = 4 Nos. 8.

Information On How The Inclusion Of Marble Dust Contribute ...

Polymer concrete mix; were revealed. Waste marble powder was utilized as a binder in cement or as a coarse or fine aggregate in the sand when manufacturing normal concrete mix. Waste marble was also used in general as fine aggregate in sand in SCC mix.

An Experimental investigation on strengths characteristics ...

cement by marble dust powder and sand by stone dust. The Dissertation work is carried out with M 30 grade concrete for which the marble powder is replaced by 0%, 5%, 10%, 15%, 20% by weight of cement. For all the mixes compressive, flexural and split tensile strengths are determined at

Experimental Study On Concrete Using Waste Marble powder ...

powder waste is increased by 15% and by further increasing of waste marble powder, compressive strength gets reduced. Specimens were casted in (150x150x150) mm moulds. keywords: Marble powder, Sand, concrete ,compressive strength, split tensile strength. 1 INTRODUCTION Cement, sand and aggregate are basic needs for any construction industry.

Marble Powder Lab - 2221 Words | Internet Public Library

To observe the performance of concrete prepared by replacement of cement and sand by marble powder as well as addition of marble powder to the standard concrete these tests were performed. For compressive strength cubes of dimensions 150mm×150mm×150mm were prepared. To check the repeatability of results three cubes of each mix were prepared ...

Review on the feasibility of Marble Dust as Replacement of ...

usual fine aggregates by varied proportion of marble powder and marble grains reveals that lifted waste marble powder (WMP) or waste marble granule (WMG) ratio has positive effect on workability as well as compressive strength of the mortar and cement concrete.

PARTIAL REPLACEMENT OF CEMENT WITH MARBLE DUST

incorporation of waste marble in concrete. Prof. Veena, G. Pathan studied the Feasibility and Need of use of Waste Marble Powder in Concrete Production. Test results indicate that the 10% of marble dust in the cement concrete gives the best results. And also increase in curing days will increase the strength of marble dust concrete

Information On How The Inclusion Of Marble Dust Contribute ...

Polymer concrete mix; were revealed. Waste marble powder was utilized as a binder in cement or as a coarse or fine aggregate in the sand when manufacturing normal concrete mix. Waste marble was also used in general as fine aggregate in sand in SCC mix.

Evaluation of the use of marble waste in hydrated lime ...

May 30, 2019 · Due to this, major ornamental marble producer countries have several researches assessing the possibility of incorporating marble powder to cement materials [18,19,20,21,22].In general, the previously mentioned researches [18,19,20,21,22] assess the feasibility of using marble powder instead of the fine aggregate and cement in concrete and mortars, while this paper

Experimental and Theoretical Study of a New Technique for ...

The marble powder was also used as an additive material in blended cement . This cement has been obtained by intergrinding marble powder with Portland cement clinker at different blend ratios. Obtained results indicate that adding 10% of marble powder provides cement that conforms to EN 197-1 standard . In addition, the marble powder was also ...

Statistical Analysis of 3-Point Bending Properties of ...

Jan 08, 2018 · The mechanical performance of concrete polymer beams subjected to 3-point bending was investigated. The polymer concrete incorporates marble powder waste and quarry sand. The results obtained showed that the type of sand, and amount of marble powder and sand aggregate affected the resistance of the polymer concrete beams significantly. The marble waste increased

UTILIZING THE WASTE OF MARBLE AND GRANITE

Cement: Type I Ordinary Portland Cement Concrete Fine Aggregates: Natural sand will be used. Coarse Aggregates: Well-graded crushed dolomite was used as coarse aggregates. The aggregates had MNA of 38 mm. Marble slurry: A marble sludge powder was used, which was obtained from the area of Shaq Al Thu’ban, Cairo, Egypt.

Experimental Investigation of Fly ash, Marble dust and ...

1. When fly ash added to cement up to 15% flexural strength of concrete increases. 2. When 10 % marble dust and 15 % wollastonite powder is normal concrete. 3. Combination 23 gives poor result in which three materials are used at a time to replace cement up to 55 %. Chart

Synergistic Effect of Marble Powder and Green Sand on the ...

The aim of this paper is to study experimentally the effect of marble powder and green sand as partial substitute for fine aggregate on the strength and durability of M40 grade concrete. The use of metakaolin as a pozzolanic admixture by using as binder replacement is also studied to assess the properties with respect to fresh and hardened state.

A study of the chemical effect of marble and granite ...

Feb 04, 2020 · For sand replacement, and by replacing 10% of sand with marble powder in (NF10), the compressive strength value rises up to 5% above the control CM. Replacing 5% of cement and 10% of sand with marble waste powder in NC5 + NF10 mix gives almost the same compressive strength value obtained from CM.

Research Paper PARTIAL REPLACEMENT OF CEMENT WITH

The concrete mix proportion (cement: fine aggregate: coarse aggregate) is 1: 1.5: 3 by volume and a water cement ratio of 0.5. Casting and Testing Detail: Total number 30 cubes and 30 cylinders were casted. Marble powder were added in concrete in step of 5% (0%, 5%, 10%, 15%, 20% ). For each percent of marble powder replacing

Cement Stone Powder S Le Layer

May 10, 1996 · Concrete Cement Stone Powder And Stone Sand. Concrete Cement Stone Powder And Stone Sand. cement by marble powder and sand by stone dust which gives the maximum strength for M 20 and M 30 grade concrete is 10 marble powder and 20 stone dust. International Research Journal of Engineering and Technology IRJET ...